Pppoe Intermediate-Agent Format-Type (Interface) - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

pppoe intermediate-agent format-type (interface)

This command takes effect only if you enable the pppoe intermediate-agent interface configuration
Note
command.
To set circuit-id or remote-id for an interface, use the pppoe intermediate-agent format-type
command. To unset the parameters, use the no form of this command.
Syntax Description
circuit-id string string
remote-id string string
Defaults No default values for circuit-id and remote-id.
Command Modes
Interface configuration mode
Command History Release
12.2(50)SG
Usage Guidelines Use the pppoe intermediate-agent format-type command to set interface-specific circuit-id and
remote-id values. If an interface-specific circuit-id is not set, the system's automatic generated circuit-id
value is used.
Examples This example shows how to set remote-id for an interface:
Switch(config-if)# pppoe intermediate-agent format-type remote-id string user5551983
This example shows how to unset circuit-id for an interface:
Switch(config)# no pppoe intermediate-agent format-type circuit-id
Related Commands Command
pppoe intermediate-agent
(interface)
pppoe intermediate-agent
(interface vlan-range)
OL-25342 -01
pppoe intermediate-agent format-type {circuit-id | remote-id} string string
no pppoe intermediate-agent format-type {circuit-id | remote-id} string string
ASCII string literal value for circuit-id.
ASCII string literal value for remote-id.
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Description
Enables the PPPoE Intermediate Agent feature on an interface.
Sets the circuit-id or remote-id for an interface vlan-range.
pppoe intermediate-agent format-type (interface)
2-529