Show Interfaces Capabilities - Cisco Catalyst 4500 Series Command Reference Manual

show interfaces capabilities

show interfaces capabilities
To display the interface capabilities for an interface or for all the interfaces on a switch, use the
show interfaces capabilities command.
Syntax Description
module mod
interface
interface-number
Defaults
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(19)EW
12.2(25)EW
12.2(31)SGA
Usage Guidelines
The interface-number argument designates the module and port number. Valid values for
interface-number depend on the chassis and module used. For example, if you have a 48-port
10/100-Mbps Fast Ethernet RJ-21 (telco connector) switching module installed in a Catalyst 4507
chassis, valid values for the slot number are from 2 to 13 and valid values for the port number are 1 to 48.
Line cards that support auto-MDIX configuration on their copper media ports include: WS-X4124-RJ45,
WS-X4148-RJ with hardware revision 3.0 or higher, and WS-X4232-GB-RJ with hardware revision 3.0
or higher.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-678
show interfaces capabilities [{module mod}]
show interfaces [interface interface-number] capabilities
(Optional) Displays information for the specified module only.
(Optional) Interface type; valid values are fastethernet, gigabitethernet,
tengigabitethernet, and port-channel.
(Optional) Port number.
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
Support for the 10-Gigabit Ethernet interface was introduced on the
Catalyst 4500 series switch.
Support for auto-MDIX reflected in command output.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-25342 -01