Installing Mounting Brackets And Cable Management Brackets - HP A10500 Series Installation Manual

Figure 7 Installing the cage nuts (A10508 as an example)
(1) Cage nuts
NOTE:
When preparing for installation, make sure that the total height of the switches to be installed is no
higher than the available installation height of the rack, and reserve enough clearance for cable
routing.

Installing mounting brackets and cable management brackets

Before installing the switch to the rack, install the cable management brackets and mounting brackets
shipped with the switch. Cable management brackets (signal cable and power cable management
brackets) are used for cabling the switch, and mounting brackets are used for attaching the chassis to
the rack.
Installing the cable management brackets
You must install the signal cable management brackets separately for the A10508-V switch. All other
A10500 switches come with the signal cable management brackets secured to the mounting brackets. In
this step, you only need to install the power cable management brackets for them.
The A10508-V has two cable management brackets—the signal cable management brackets are
•
installed at the upper part of the switch, and the power cable management brackets are installed at
9