NOTE:
A combo interface is a logical interface that comprises one fiber port (Gigabit/100-Mbps SFP port)
•
and one copper port (10/100/1000Base-T GE port). The two ports share one interface view and
cannot work simultaneously. When you use the combo enable { copper | fiber } command to enable
one port, the other port is disabled automatically.
If a port is brought down by the shutdown command, use the undo shutdown command to bring up
•
the interface.
After an interface fails, if the switch has an idle interface of the same type, you can plug the cable
•
into the idle interface.
Check that the speed and duplex settings of the interfaces of a link are the same. Make sure that
7.
two interfaces can work together.
If the failure still exists, contact HP.
8.
43