HP A10500 Series Installation Manual page 94

Figure 51 Removing the mounting brackets from the chassis (A10508)
Put the mounting brackets into the box.
3.
Removing the cable management brackets
The A10508-V has two cable management brackets—the one on the chassis bottom routes power
cables, and the one on the chassis top routes signal cables.
The A10504 and A10508 provide a cable management bracket at the chassis bottom to route power
cables. The procedure for removing the cable management bracket is similar to that of the A10508-V.
To remove the cable management brackets:
Prepare the packing bag of the cable management brackets. Make sure that the bag is clean, dry,
1.
and not damaged.
Use a Phillips screwdriver to loosen the screws that attach the cable management brackets to the
2.
chassis, and then remove the cable management brackets.
Put the cable management brackets into the bag.
3.
89