Configuration Example - HP A10500 Series Installation Manual

Configuration example

Configuring Telnet service
# Enter system view.
<Sysname> system-view
# Enable the Telnet server.
[Sysname] telnet server enable
# Enter the user interface view VTY 0.
[Sysname] user-interface vty 0
# Enable password authentication on the user interface.
[Sysname-ui-vty0] authentication-mode password
# Set the password to hello.
[Sysname-ui-vty0] set authentication password cipher hello
# Set the user privilege level to 3 so all Telnet users access VTY 0 can use all commands.
[Sysname-ui-vty0] user privilege level 3
[Sysname-ui-vty0] quit
Configuring the basic network settings
Configure IP addresses
•
# Create VLAN-interface 1.
[Sysname] interface vlan-interface 1
# Assign an IP address, for example, 192.168.0.1, to VLAN-interface 1.
[Sysname-Vlan-interface1] ip address 192.168.0.1 24
[Sysname-Vlan-interface1] quit
Configure static routes
•
# Configure a static route, with the destination IP address 172.16.1.0 and the next hop IP address
192.168.0.2.
[Sysname] ip route-static 172.16.1.0 255.255.255.0 192.168.0.2
Configure VLANs
•
# Create VLAN 10 and enter its view.
[Sysname] vlan 10
[Sysname-vlan10]
# Assign port GigabitEthernet 1/0/1 to VLAN 10.
[Sysname-vlan10] port gigabitethernet 1/0/1
[Sysname-vlan10] quit
Configure MSTP
•
# Create an MST region named example, map VLAN 10 to instance 1, and set the MSTP revision level
to 0.
[Sysname] stp region-configuration
[Sysname-mst-region] region-name example
[Sysname-mst-region] instance 1 vlan 10
[Sysname-mst-region] revision-level 0
# Activate the MST region configuration.
36