Hitachi StarBoardLink EZ User Manual page 12

StarBoardLink EZ
- Select a level and stable position.
- Do not set it up near equipment that might generate electromagnetic waves or
radio frequencies, such as radio transmitters, televisions, copying machines or
air conditioners.
- Avoid locations that are dusty, that are subject to extremely high or low
temperatures or humidity, or that are exposed to direct sunlight.
Use an input tool with a thickness of least 7 mm.
When inputting to this product, use a tool that is at least 7 mm. If a pen or
similar tool with a thickness of less than 7 mm is used, the input will be
unstable.
Also, do not use tools with a sharp tip, such as a ballpoint pen. If such a tool is
used incorrectly, it could damage the surface of the board.
Using infrared and compact cameras, this product captures the
image (shadow) of a pen or finger and detects the
corresponding coordinate position. Do not operate near
lighting that will obstruct the capture of the image.
- Locations where the surface or side of the projection area are exposed to direct
sunlight.
- Locations in which there are light fittings with many light bulbs or infrared
rays directly above the projection area.
NOTICE
Notice Contents
11
Safe Handling
Page(s)
P.2-1
P.3-1
P.2-11
P.4-4
English