How To User The Electronic Pen; Inserting The Battery - Hitachi StarBoardLink EZ User Manual

StarBoardLink EZ

3.3 How to User the Electronic Pen

This section gives a basic description of how to use the electronic pen (option).

3.3.1 Inserting the Battery

Perform the preparations for using the electronic pen.
CAUTION
Be sure to install batteries correctly.
Do not install batteries with positive and negative terminals reversed, or use batteries
other than the type specified. It will cause pen malfunctions and excess heat, or burns to
the hand.
Be sure to provide insulation during disposal.
Be sure to insulate the positive and negative terminals of the battery using cellophane
tape, or similar material when disposing of batteries. Disposing of batteries without
insulating them may lead to overheating, bursting, or ignition due to shorting, resulting
in personal injury or fire. Furthermore, be sure to follow all local rules and regulations
regarding proper battery disposal. If within the EU, be sure to follow Batteries
Directive.[Batteries directive (2006/66/EC)]
[1] Insert the battery into the electronic pen.
(1) Rotate the battery cover ¼
counter-clockwise, and pull it to
remove it.
(2) As shown in the figure, insert the
AAA alkaline battery so that the +
side faces the outside.
(3) Press the battery cover on, and rotate
it clockwise ¼ turn to fix it in place.
(Be careful not to over tighten the
cover, as doing so may damage it.)
3-6
How to use
English