Adjusting The Height Of The Digitizer - Hitachi StarBoardLink EZ User Manual

StarBoardLink EZ

4.3 Adjusting the Height of the Digitizer

If setup is not completed correctly after following the procedures in "2. Assembly and
Setup", adjust the height of the digitizer.
Before adjusting the height
Check the details of the precautions on pages 2-1 to 2-14, and also check that the devices
have been installed correctly.
However, adjusting the height may affect detection performance.
(1) Detach the digitizer. At this time remove the cable cover and USB cable together.
(2) Rotate the 3 adjusters on the back of the digitizer counterclockwise as far as possible,
and raise the height of the digitizer.
(3) Refer to page 2-4 (or page 2-6), and attach the digitizer.
(4) Refer to "Sensor Adjustments" on page 2-10, and adjust the sensor.
After the adjustments are completed, check that input can be performed correctly.
4-6
Appendix
English