Assembly And Setup - Hitachi StarBoardLink EZ User Manual

StarBoardLink EZ

2. Assembly and Setup

Be sure to follow the precautions below when installing the StarBoard.
Important
Use on a flat surface.
This product is designed so that stable input is achieved when used on a flat surface.
Do not use on an uneven or curved surface.
When using the double-sided tape to install this product.
Attach to a flat whiteboard or wall that does not have any unevenness.
Do not touch the adhesive surface of the tape, or reattach the tape in different
positions, as doing so reduces the adhesive strength of the tape.
However, in the following locations the double-sided tape will not have enough
adhesive strength and cannot be used. Using the double-sided tape in such locations
may cause damage.
・ Uneven surfaces, textured surfaces, curved surfaces
・ On wallpaper (vinyl chloride ,cloth, or paper wallpaper), clay walls, sand walls
・ Hot locations above 40°C
・ Surfaces treated with wax, fluorine, or mold prevention materials
・ Glass surfaces that are in direct sunlight
・ Locations where the product may be splashed with water or rain, such as inside
bathrooms or outdoors
*After installing with double-sided tape, always be sure to fix in place with
screws.
WARNINGS
Install this product on a vertical surface.
Do not install on a slanted surface or ceiling. Failure to comply may cause the stand
to fall, resulting in personal injury, or may cause damage to this product due to shock
of impact from the board falling.
If magnets are not used to install this product, fix it in place with screws.
Failure to comply may cause the stand to fall, resulting in personal injury, or may
cause damage to this product due to shock of impact from the board falling.
NOTICE
- Select a level and stable position.
- Do not set it up near equipment that might generate electromagnetic waves or
radio frequencies, such as radio transmitters, televisions, copying machines or air
conditioners.
- Avoid locations that are dusty, that are subject to extremely high or low
temperatures or humidity, or that are exposed to direct sunlight.
2-1
Assembly and Setup
English