Using The Setting Dial Like A Potentiometer At The Operation - Mitsubishi Electric F700 Instruction Manual

Start/stop from the operation panel (PU
operation mode)
3.5.2

Using the setting dial like a potentiometer at the operation.

POINT
Set "0" (extended mode parameter valid) in Pr. 160 User group read selection.
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Operation example Change the frequency from 0Hz to 60Hz during operation
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Press
setting mode.
4.
Turn until
5.
Press
" " (initial value) appears.
6.
Turn to change it to
the setting value of "
7.
Press
8.
Change Pr. 161 to the setting value of "
in the similar manner. (Refer to step 4 to 7.)
9.
Mode/monitor check
Press
monitor/frequency monitor.
10.
Press
11.
Turn
The flickering frequency is the set frequency.
You need not press
REMARKS
· If flickering "60.00" turns to "0.0", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
· Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning
CAUTION
· When using setting dial, the frequency goes up to the set value of Pr. 1 Maximum frequency (initial value is 120Hz (55K or less)/
60Hz (75K or more)).
Adjust Pr. 1 Maximum frequency setting according to the application.
50
Operation
to choose the PU operation
to choose the parameter
(Pr. 160) appears.
to read the present set value.
".
to set.
twice to choose
(or ) to start the inverter.
until " " appears.
.
Display
PU indication is lit.
Flicker ··· Parameter setting complete!!
"
Flicker ··· Parameter setting complete!!
The frequency flickers for about 5s.
The parameter number
previously read appears.
.