Setting Up Programmed Operations; Example Settings - Sanyo SHA TM64 AGB Instruction Manual

Schedule Timer

Setting Up Programmed Operations

Correctly set the present time and today's day of the week.
Unless both are correctly set, the programs will not run as expected.
Up to 6 programmed operations can be set per day for each group and day
of the week.
A combination of the below operations can be set for each timer program.
– Air conditioner starting/stopping
– Remote controller operation enable/disable *1
To change the settings of an existing program, use the same procedure used
to set up a new program as below.
*1 The remote controller operation enable/disable setting is disabled depend-
ing on installation conditions. If so,
button is pressed.
For more information, contact your dealer.
STEP 1 Press the PROGRAM button to select a group.
When the PROGRAM button is pressed, the group No. and to-
day's day of the week start blinking and the present time indica-
tion changes to a blinking "PG-1".
Press the GROUP button to select a group for programmed op-
eration and then press the SET button.
NOTE
Group selection is disabled depending on installation conditions.
If so, proceed to the next step.
The number of selectable groups is set during installation.
STEP 2 Press the DAY button and select a day of the week for pro-
grammed operation.
When the SET button is pressed, the program schedule marker
changes from blinking to lighting and, at the same time,
the time set in program
indication changes to a blinking "PG-2".
NOTE
The currently selected day of the week blinks slowly at this time.
appears on the display when the
starts blinking. Also, the present time

Example settings

3