Sanyo SHA TM64 AGB Instruction Manual page 8

Schedule Timer
Setting Errors
If time is set as shown below while setting up a program, "ERROR" is displayed (the
Therefore, correct the time setting.
If Program Times are the Same
STEP 1 Every time the SET button is pressed, the setting mode switches between programmed operations of the same
time setting (
STEP 2 Change the time setting with the HH and MM buttons so that the times are no longer the same.
STEP 3 Press the SET button and check "ERROR" is not displayed.
STEP 4 Press the PROGRAM button to end the setting mode.
Example of Time Settings That Do Not Cause Errors
The below time settings do not generate an error.
1) When ON and OFF times are staggered
and in the above example), therefore select the time setting to correct.
2) When OFF time is earlier than ON time
indication blinks).
3