9. STANDARD ADJUSTMENTS
(Bottom)
1169B
(Viewed from above)
5. Remove the two screws (7), and then remove the auxiliary clamp cylinder assembly (8).
6. Replace the air hoses (2) and (3) with the optional air hoses (9) and (10).
7. Remove retaining ring C (11) and pull out the shaft (12).
8. Insert the shaft (12) into the auxiliary clamp S holder (13) in the direction shown in the illustration, and then install retaining
ring C (11).
9. Set the joint (14) and the cylinder rod (15) so that they are facing as shown in the illustration.
(Top)
(Bottom)
1170B
10. Insert the shaft (16) of the auxiliary clamp connecting rod into the hole in the feed base, and then install retaining ring C (6).
11. Tighten the two screws (7).
(Continued on next page)
110
RH-9820