3-4-2. When embedding into the table
1642B
1650B
1651B
0347B
(rear)
RH-9820
3. INSTALLATION
(1) Bed support plates [4 pcs.]
(2) Bolts [16 pcs.]
*
Install so that they are horizontal to
the bed base.
NOTE:
When placing the machine head
onto the table, have four or more
people hold the machine head by the
places indicated by the
in the illustration.
Do not hold by the head support
lever (3).
(4) Rubber sheets [12 pcs.]
(5) Bolts [4 pcs.]
(6) Washers (large) [4 pcs.]
(7) Nuts [4 pcs.]
After installing the machine head,
remove the fixing bolt (8).
Tilt back the machine head and install
the rubber caps (9) to the four holes in
the bed base.
NOTE:
The fixing bolt (8) is needed when
moving the machine head, so store
it in a safe place.
Be sure to use the rubber sheets (4).
If they are not used, the amount of
vibration will be excessive.
locations
10