Standard Adjustments; Changing The Gluing Width; Replacing The Nozzle; Settings When Changing The Gluing Width - Brother BM-2000 Instruction Manual

12 STANDARD ADJUSTMENTS

12.1 Changing the gluing width

12.1.1 Replacing the nozzle

The gluing width can be changed by replacing the nozzle.
Three types of nozzle are available, with gluing widths of 6 mm, 8 mm and 10 mm.
Refer to "11.1 Replacing the nozzle" for details on replacing the nozzle.

12.1.2 Settings when changing the gluing width

Carry out the following procedures when installing a nozzle with a different gluing width.
[Changing the gluing width setting]
1. Display the memory switch setting screen. Refer to "3.5" for details on the display method.
2. Change the setting for memory switch No. 500 to match the gluing width for the nozzle which has been installed.
No. Name
500 Nozzle gluing width
[Upper roller position adjustment]
1. Remove the three screws (1), and then remove the rear cover L (2).
2. Loosen the three screws (3).
Details
Gluing width of installed nozzle
BM-2000
12 STANDARD ADJUSTMENTS
Setting
range
6～10 [mm]
(1)
(2)
(3)
Step Initial
value
2 8
85