Table of Contents
Advertisement
10 CLEANING
If the upper and lower edge control rollers and the end detection sensor do not operate correctly, it is possible that glue, dirt or
other foreign particles are adhering to the reflector. In such cases, wipe off the foreign particles.
[Cleaning the nozzle reflector]
74
(3)
BM-2000
1. Press the
key to display the test screen.
2. Press the NOZZLE switch (1) to raise the nozzle (2) to
the highest position.
3. Use a soft cloth to wipe off any glue, dirt or other foreign
particles which are adhering to the reflector (3) of the
nozzle (1).
NOTE:
⚫
Do not wipe the reflector too firmly, otherwise it may
peel off.
⚫
Do not use any chemicals when wiping the reflector.
They may damage the reflector and cause the edge
control roller to stop working correctly.
Advertisement
Table of Contents
