Table of Contents
Advertisement
If problems such as uneven application of the glue occur because the nozzle discharge holes are blocked with glue, carry out
the following procedure to clean the nozzle discharge holes.
(2
)
1. Press the
* The display will switch to test mode.
2. Push the NOZZLE switch (1) to move the nozzle (2) to its
highest position.
(1
)
Place something such as a cup underneath the nozzle
(2) to prevent any glue from dripping onto the table.
BM-2000
10 CLEANING
key to switch to test mode.
65
Advertisement
Table of Contents
