Kenwood CK 404 G Instructions For Use Manual page 41

ELECTRICAL FEEDER CABLE CONNECTION
The operations must be executed by a qualified technician.
To connect the supply cable:
• Remove the screws securing the cover "
• Feed the supply cable through the cable clamp "
be of a suitable size for the current requirements of the appliance; see the section
"Feeder cable section".
• Connect the wires to the terminal block "
connect the phase and neutral wires to the terminal block "B" and the earth wire to the
terminal "PE" as shown in figure 11.2.
• Take up any slack in the cable and secure with the cable clamp "
• Replace the cover "
N.B. The earth conductor must be left about 3 cm longer than the others.
FEEDER CABLE SPECIFICATIONS
TYPE H05RR-F
230 V AC 3 X 0,75 mm
B
A
Fig. 11.2
A".
2
PE
N
D
L
A" on the rear of the cooker (fig. 11.2).
D" (fig. 11.2). The supply cable must
B" as shown in the diagram in figure 11.3; or
230
L
1
Fig. 11.3
D".
N PE
(L )
2
41