NEC Univerge SV8100 Features And Specifications Manual page 817

UNIVERGE SV8100
Program
Program Name
Number
84-26-02 IPL Basic Setup – RTP Port
Number
84-26-03 IPL Basic Setup – RTCP Port
Number (RTP Port Number + 1)
NAT Traversal:
Program
Program Name
Number
15-05-45 IP Telephone Terminal Basic
Data Setup – NAT Plug and Play
IP Multiline Station (SIP)
Description/Comments
Assign the RTP port number to be
used for each DSP on the IPLA/
IPLB.
Only even numbered ports

are supported.
Define the TCP port number for
RTCP to use for each DSP.
Description/Comments
This Program is valid when
Program 10-46-14 is On (NAT
feature activated).
Select sending RTP port number
to remote Router, use from
negotiation result (0) or received
RTP packet (1).
SV8100 uses this program to
decide a destination port of RTP
transmitting packets from IPLB to
a remote IP terminal. If "0:OFF" is
selected, the destination port of
RTP transmitting packets will be a
SIP/SDP negotiation result.(same
behavior as before). If you chose
"1:ON", the destination port of RTP
transmitting packet will be the
same port of a source port of a
receiving RTP packet on IPLB.
Assigned Data
1
0~65534
Defaults:
VoIP GW1 = 10020
VoIP GW2 = 10052
VoIP GW3 = 10084
VoIP GW4 = 10116
VoIP GW5 = 10148
VoIP GW6 = 10180
VoIP GW7 = 10212
VoIP GW8 = 10244
0~65534
Defaults:
VoIP GW1 = 10021
VoIP GW2 = 10053
VoIP GW3 = 10085
VoIP GW4 = 10117
VoIP GW5 = 10149
VoIP GW6 = 10181
VoIP GW7 = 10213
VoIP GW8 = 10245
Assigned Data
1
0 = Disable
1 = Enable
(default = 0)

Issue 11.0
Level
2 3


Level
2 3
2 - 785