Installing A 3.5 Inch Hard-Drive Cage - Dell DL1000 Owner's Manual

4. Disconnect the power and data cables from the hard drive.
NOTE: The power and data cables are connected to the PERC H310 card cable adapter. To
disconnect the power and data cables, remove the PERC H310 card cable adapter from the
hard drive.
5. Pull the release pin, slide the hard-drive cage away from the chassis wall.
6. Lift the hard-drive cage away from the chassis.
Figure 8. Removing and Installing a 3.5-Inch Hard-Drive (HDD1) Cage
1. power cable
3. hard-drive cage
5. hard drive
7. standoffs (4)

Installing A 3.5 Inch Hard-Drive Cage

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: Your system supports two 3.5-inch hard-drive cages, HDD0 and HDD1. The HDD0 and
HDD1 cages cannot be used interchangeably.
28
2. SATA cable
4. release pin
6. slots (4)