Dell Perc H310 Card And Risers; Removing The Dell Perc H310 Card - Dell DL1000 Owner's Manual

7. Press down on the memory module with your thumbs until the memory module snaps into place.
8. Repeat step 4 through step 7 of this procedure to install the remaining memory modules.
9. Replace the cooling shroud.
10. Close the system.
11. Reconnect the system to the electrical outlet and turn on the system, including any attached
peripherals.
12. Press <F2> to enter the System Setup, and check the memory settings.
The system should have already changed the value to reflect the newly installed memory.
13. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat
step 4 through step 7 of this procedure, checking to ensure that the memory modules are firmly
seated in their sockets.
14. Run the appropriate diagnostic test.
For more information, see
Figure 16. Installing the Memory Module
1. memory module
3. memory-module socket alignment key

Dell PERC H310 Card And Risers

Removing The Dell PERC H310 Card

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
2. Open the system.
3. Disconnect any cables connected to the PERC H310 card or the riser.
4. Lift and rotate the PERC H310 card latch.
40
Using System Diagnostics.
2. memory-module ejectors
4. memory-module alignment key