Installing The Dell Perc H310 Card - Dell DL1000 Owner's Manual

5. Hold the PERC H310 card by its edges and slide the card out to remove it from the connector on the
riser.
6. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot
opening and close the PERC H310 card latch.
NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust
and dirt out of the system and aid in proper cooling and airflow inside the system.
7. Close the system.
8. Reconnect the system to the electrical outlet and turn the system on, including any attached
peripherals.
Figure 17. Removing and Installing the PERC H310 Card on the Riser
1. PERC H310 connector
3. PERC H310

Installing The Dell PERC H310 Card

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Unpack the PERC H310 and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
3. Open the system.
4. Locate the PERC H310 card connector on the riser.
5. Lift and rotate the PERC H310 card latch and remove the filler bracket.
6. Holding the card by its edges, position the card so that the card-edge connector aligns with the
PERCH310 card connector.
7. Align the PERC H310 card bracket with the hook on the chassis.
2. PERC H310 latch
41