Medisana MTX Instruction Manual page 35

3.4
Setting the alarm
1. You can set the date and time by pressing down the TIMER button
several seconds until
2. Press the TIMER button
appears on the display and
3. Press the TIMER button
can switch the radio clock on or off by pressing the MEMO button
If the radio clock is switched off, you can press the TIMER button
the time manually.
4. The selected user memory appears on the display together with the flash-
ing year.
- Press the TIMER button
to flash.
- Press the TIMER button
- Press the TIMER button
flash.
- Press the TIMER button
- You can set the current date and time (year, month, day, hours and min-
utes) by pressing the MEMO button
with the TIMER button
twice each in succession before the device returns to standby mode. In
standby mode, the time is displayed permanently.
NOTE
If, during manual time setting, you press the START button
you exit the time setting mode.
The date and time values you have entered so far are kept.
- : - -
" " is displayed if you did not set the time previously.
Your MEDISANA MTX blood pressure meter is equipped with an alarm func-
tion, with which the two users can set three alarm times each, in order to take
medication are regular intervals, for example.
Make sure that the device is in standby mode and your own user memory
has been selected.
1. Press the TIMERbutton
both buttons until the alarm symbol
2. Release both buttons. " 1 " flashes at the bottom right of the display for
Alarm 1. You can use the MEMO button
Alarm 3.
3. Press the TIMER button
es. Use the MEMO button
then the minutes.
3 Getting Started
appears on the display.
again. After you release the button,
appears below this.
again. and appear in the display. You
again to display the date; the month starts
again and the day starts to flash.
again to display the time. The hour starts to
again and the minutes start to flash.
and confirm the date and time
. Then the date and time you set are shown
followed by the MEMO button
appears on the display.
to select Alarm 1, Alarm 2 or
. The display for entering the alarm time flash-
to enter the alarm time: first the hours and
GB
for
.
to set
,
. Hold down
25