Table of Contents
Advertisement
2. Sending Scan Files to Folders
7.
Depending on the destination setting, enter the password for logging on to the computer.
Press [Manual Entry] for the password to display the soft keyboard.
8.
Press [Connection Test].
A connection test is performed to check whether the specified shared folder exists.
If the message "Connection with PC has failed. Check the settings." appears, see "Troubleshooting
2
When Using the Scanner Function", Troubleshooting.
9.
Check the connection test result, and then press [Exit].
10.
Press [OK].
• If authentication is required to access the folder, the login screen appears. Enter the user name
and password.
• If you change the protocol after entering the path name, user name, or password, a confirmation
message appears.
• To change the path for the folder that has been entered, press [Edit] on the left side of the
destination field. Enter the correct path for the folder, and then press [OK].
• The connection test may take time.
• You may not be able to press [Connection Test] right after pressing [Cancel] during a connection
test.
• Even if the connection test was successful, the machine may fail to transfer the file if you do not
have write privileges for the file or there is not enough free hard disk space.
• You can register the path to the destination in the machine's address book. For details, see
"Registering the Path to the Selected Destination in the Address Book".
• p.73 "Registering the Path to the Selected Destination in the Address Book"
Specifying the path by browsing the network for destinations
You can browse computers on the network for the destination folder, and then specify the path.
66
Advertisement
Table of Contents
