Table of Contents
Advertisement
CAUTION: If you are not operating your system with a redundant (tenth) SFM3, you must install an SFM3
blank to avoid overheating and ensure EMI containment.
Step
Task
Remove an SFM3 from the anti-static packaging.
1
Align the SFM3 with the guide and gently slide it into the slot until you feel the connectors engage with the
2
chassis backplane.
NOTE:
Hold the SFM3 by the edges. Avoid touching the printed circuit board and connector pins. Extend the
ejector lever before you insert the SFM3 into the slot.
Rotate the lever to seat the backplane connectors and card in place.
3
Secure each SFM3 in place by tightening the captive screw.
4
Continue the process for the remaining SFM3s.
5
Align any blank panels with the guides and gently slide toward the backplane. Secure each blank panel by
6
tightening the single captive screw.
NOTE: If you are not operating your E1200 system with redundancy, your SFM3 package will include blank
panels. Blanks are slot covers that have no board components or connector pins.
SFM3 Front Panel and LEDs
Table 9-2
illustrates the SFM3 front panel and LEDs.
Table 9-2. SFM3 Front Panel and LED Descriptions
CC-E-SFM3
Active
Status
Line Card Cable Management Systems
Dell Force10 provides a variety of E1200 chassis cable management systems to manage your fiber optic
and auxiliary cables connecting to line cards. For details, see the Dell Force10 price list. For installation
instructions, see the instructions that come with the specific cable management system.
Assy
Serial
LED
Description
Active
Green: active and passing traffic
Unlit: in standby mode
Status
Green: operational
Flashing Amber: communication timeout or
booting
Amber: fault detected
Unlit: no power
Installing RPMs, Line Cards, and SFM3s
49
|
Advertisement
Table of Contents
