Table of Contents
Advertisement
• The green (online) LEDs for the fan trays, Power Supplies, RPMs, SFM3s, and line cards should be lit
and remain lit as long as the system is receiving power and is operational.
• The fans should be operating.
• The green (online) fan tray, power module, RPM, SFM, and line card LEDs should be lit and remain lit
as long as the system is receiving power and is operational.
When you supply power to the E1200 system, the system performs a series of power-on self tests. RPM,
line card, and SFM3 LEDs blink as the diagnostic programs run. No user interaction is required at this
point. Observe the process on your console monitor. When the boot process is complete, the card LEDs
remain online (green) and the console monitor displays the Command Line Interface (CLI) prompt.
NOTE: Do not press any keys or control sequences at any time during the boot process. Doing so may cause
the boot process to terminate.
Refer to the FTOS Configuration Guide for initial configuration procedures and configuration
instructions.
Booting from the BOOT_USER Prompt
The initial boot operation automatically brings up the system to the runtime CLI. To interrupt the
automatic boot process, issue a break key sequence (CNTL^). The console monitor will display the
BOOT_USER #
default
prompt. Refer to
process.
Chapter A, System Boot
for instructions to continue the boot
57
Powering Up
|
Advertisement
Table of Contents
