Table of Contents
Advertisement
Manual Registration
In manual registration, the repeater can be registered to another repeater to create a cascade configuration.
WARNING
•
When installing or testing a product with an external AC adaptor, the AC adaptor should be
plugged into a wall outlet or floor-mounted AC outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected.
•
Completely insert the AC adaptor/power plug into the AC outlet. Failure to do so may cause
electric shock and/or excessive heat resulting in a fire.
Note
It is necessary to check the ID of the repeater you are attempting to register to (destination repeater) just
before starting the manual registration.
1.
Check the ID of the destination repeater.
a.
In Operation mode, press the destination repeater's PROGRAM button to switch to ID Confirmation
mode.
The ID is indicated by the number of times the RSSI/ID LED flashes green.
b.
Return the destination repeater to Operation mode by pressing the PROGRAM button again.
2.
Turn on the repeater you want to register by connecting the AC adaptor.
The STATUS LED and the RSSI/ID LED will turn amber for 2 seconds.
3.
When the repeater is unregistered:
The STATUS LED will flash red, and the repeater automatically enters Easy Registration mode.
When the repeater is registered:
The repeater automatically enters Operation mode.
4.
Press and hold down the PROGRAM button for 5 seconds.
The STATUS LED will flash green quickly.
5.
Release the PROGRAM button to enter Manual Registration mode.
The STATUS LED will turn green.
The RSSI/ID LED will flash red once to indicate that the ID is currently set to 1.
6.
If the ID of the destination repeater was not 1, press the PROGRAM button to select the ID that matches
the destination repeater.
The ID will change by one each time the PROGRAM button is pressed. (e.g., If you select ID3 by pressing
the button 2 times, the RSSI/ID LED will flash 3 times.)
7.
Press and hold down the PROGRAM button for 5 seconds to assign the ID to the repeater.
The RSSI/ID LED will turn red.
8.
Release the PROGRAM button to reset the repeater.
The STATUS LED and the RSSI/ID LED will turn amber for 2 seconds and then the STATUS LED start
flashing red. The repeater will then start searching for a repeater with the assigned ID.
9.
When the repeater has found a repeater with the assigned ID, the STATUS LED will turn green.
Registration is complete.
Hook
To AC Outlet
3 Registering the Repeater
Installation Manual
15
Hide quick links:
Advertisement
Table of Contents
