Installing The Repeater - Panasonic KX-A405 Installation Manual

Installing the Repeater

a.
After all registration is complete, place the repeater where you want to install it.
Repeater Coverage Area
As a guideline, the example below shows the size of the coverage area where one repeater can
synchronise with a CS/destination repeater, or provide coverage for a PS, if it is installed in an area with
no obstacles.
Note
•
The distance may vary depending on the environment.
•
If the repeater's STATUS LED and RSSI/ID LED turn green (the radio signal strength level is strong)
after turning on the repeater, the site is suitable for installing the repeater.
b.
Turn on the repeater by connecting the AC adaptor.
The repeater enters Operation mode.
•
If the STATUS LED and the RSSI/ID LED turn green (the radio signal strength level is strong), the site
is suitable for installing the repeater.
•
If the RSSI/ID LED turns amber or red (the radio signal strength level is weak or out of range), turn off
the repeater by disconnecting the AC adaptor. Then, move the repeater closer to the CS/destination
repeater, turn on the repeater again by connecting the AC adaptor, and confirm that the RSSI/ID LED
turns green.
c.
Check whether the PS can be used at any location within the coverage area required by the user. For
details about conducting the site survey using a PS, refer to "Site Survey Mode".
A
Repeater Coverage Area for Synchronisation
A
between CS/Destination Repeater
Maximum Distance: 40 m to 50 m
Repeater Coverage Area for Using PS
B
Maximum Distance: 50 m to 60 m
B
2 Procedure Overview
Installation Manual 13