Erasing The Track Being Played (Track Erase) - Kenwood DM-9090 Instruction Manual

Use the following procedure to erase a single track being
played.
40
Be careful in using this operation because a track cannot be
recovered once it has been erased.
Preparation
1 Play a MD.
2 Press the EDIT/SPACE key to switch the
editing mode on.

Erasing the track being played (TRACK ERASE)

1
Select "ERASE".
1 Select "ERASE".
2 Set the selection (by pressing the JOG
DIAL).
2
Confirm that the track has been erased.
3
Execute the track erasure operation.
JOG DIAL
4 ¢
DOWN U P
PUSH SET
JOG DIAL
4 ¢
DOWN U P
PUSH SET
JOG DIAL
4 ¢
DOWN U P
PUSH SET
ENTER
The modes are switched by rotating the JOG DIAL.
1 DIVIDE?
: Dividing a track
2 COMBINE? : Combining tracks
3 ERASE?
: Erasing track(s)
4 MOVE?
: Moving (reordering) tracks
÷ Editing is aborted if no operation has been performed for 8 seconds.
L 40 30
21 18
R
PGM SEARCH
E R A S E
Track No. to be erased
L 40 30 21 18
R
PGM SEARCH
-
Indicates erase operation.
L 40 30 21 18
R
PGM SEARCH
o k
Confirm that the track has been erased.
Display after execution
"EDIT NOW!" : When editing is in progress
"COMPLETE!" : When editing is completed successfully
"CAN'T EDIT" : When editing is incomplete
÷ It takes a while until the execution completes.
÷ The track being played is erased (together with its track title).
÷ If you execute an editing operation by mistake, the condition before
editing can be recovered by performing the "EDIT CANCEL" opera-
tion.
Editing
DM-9090 (En)
15 OVER ( dB)
12 9 7 5 3 1 0 ANALOG
1
?
MONITOR
15 12 9 7 5 3 1 0 OVER ( dB) ANALOG
1
|
0 0 3 ?
MONITOR
15 12 9 7 3 1 0 OVER ( dB)
5 ANALOG
1
?
MONITOR
DIGITAL
2 3
32kHz
44.1kHz
48kHz
DIGITAL
2 3
32kHz
44.1kHz
48kHz
DIGITAL
2 3
32kHz
44.1kHz
48kHz
‹