Synchro Recording With Cd Playback; Digital Recording And Scms - Kenwood DM-9090 Instruction Manual

Synchro recording with CD playback

30
By connecting this unit with a KENWOOD "
using system control cords, the recording of MD can be started in synchronism with the playback of the CD player.
1 Set the amplifier's input selector to CD.
2 Put the CD player in pause mode.
3 Select the CD track to be recorded using the 4 or ¢ key.
4 Put the MD recorder in record-pause mode.
5 Start playback of the CD player.

DIGITAL recording and SCMS

Note that the digital recording of Mini Discs is not possible in the following cases.
If the digital source has a copy prohibition code, "001 SCMS ON" is displayed and the unit enters record-pause mode. (This
message is displayed when copy prohibition is encountered during recording of track number "001".)
Note on the sampling rate converter
Three types of digital signals are usually used according to the sampling frequencies. The sampling frequencies vary
depending on the types of digital equipment as shown below.
48 kHz : Standard mode of DAT, B mode broadcasting of BS tuner, etc.
44.1 kHz : Standard mode of DAT, CD, MD, etc.
32 kHz : Standard and long-hour modes of DAT, A mode broadcasting of BS tuner, etc.
In general, high-quality recording based on digital signal transmission is available only when the sampling frequency of the
source equipment matches that of the recorder equipment. However, this unit incorporates a sampling rate converter so that
it can also record digital signals sampled at 48 kHz and 32 kHz by converting their sampling frequency into the sampling
frequency of MD (44.1 kHz).
The SCMS may be activated with certain type of satellite broadcasting.
(DAT: Digital Audio Tape deck)
SCMS (Serial Copy Management System)
Designed for copyright protection, the SCMS is a pre-
scription that copying of digital signals as they are in the
digital form between digital audio equipment is allowable
only for one generation.
Copy using digital
input
Copy using analog
input
Copy using analog
input
Copy using digital
input
" type amplifier and CD player, which are equipped with system control jacks,
Copy using digital
input
Digital copy can-
not be repeated.
Copy using analog
input
Copy using digital
input
To stop recording
Press the 7 key, then press the 0 key.
Faded recording of MD
The fade mode of the unit is switched on/off every time
the FADE key is pressed.
Recording with fade-in:
When recording is initiated during stop (or pause) in the fade
mode, recording starts from ATT = - `, increases to the previously
set recording level and continues at this level.
Recording with fade-out:
When recording is stopped during recording in the fade mode, the
current recording level decreases to ATT = - ` then recording
stops.
If recording is continued until the end of disc, fade-out occurs
automatically before the unit stops recording.
Fade-in and fade-out
Fade-out : Ending of music after gradual decrease in volume.
Fade-in : Beginning of music after gradual increase in volume.
Gradual sound
decrease
1st track
Fade-out
Recording (DIGITAL input)
DM-9090 (En)
Gradual sound
increase
2nd track
Fade-in