Recording (Analog Input); Analog Recording - Kenwood DM-9090 Instruction Manual

Recording (ANALOG input)

The input jacks connected with audio cords accept analog signals. This unit records the analog signal from the REC IN jacks by
converting it into digital signal. (This recording is simply referred to as analog recording.)
26
Preparation
1 Open the write protect tab of the Mini
Disc to make it recordable.
2 Load the Mini Disc.
3 Check the remaining recording time.
4 Set the amplifier's input selector to the
source to be recorded.

ANALOG recording

1
Adjust the settings if required.
1 Switch the REC MODE on.
2 Select the setting adjustment mode.
3 Set the selection (by pressing the JOG
DIAL).
Go to step 2 if setting adjustments are not
required.
2
Select ANALOG or MONO.
7
o
REC MODE
/CHARA.
JOG DIAL
4 ¢
DOWN U P
PUSH SET
JOG DIAL
4 ¢
DOWN U P
PUSH SET
REC INPUT
Each press switches the mode.
1 REC MODE : off
2 REC MODE : on ("D.REC LEVEL?" displayed.)
The modes are switched by rotating the JOG DIAL.
1 D. REC LEVEL?
: Digital recording level setting.
2 AUTO TIME?
: Setting of the time for detecting a no-sound
blank section during automatic track num-
ber marking.
3 AUTO LEVEL?
: Setting of the level for detecting a non-
sound blank section during automatic track
number marking.
4 FADE TIME?
: Setting of the fading time in fade-in and
fade-out.
5 REC= WRITING? : Setting of the UTOC writing after recording.
÷ For details on the setting adjustment modes, see "REC MODE key".
÷ The "D.REC LEVEL" and "FADE TIME" settings are not used during
analog source recording.
Each press switches the mode.
1 ANALOG : Analog "stereo mode"
2 DIGITAL 1 : Coaxial input mode
3 DIGITAL 2 : Optical input mode
4 DIGITAL 3 : Coaxial input mode
5 MONO
: Analog "monaural long-play mode"
L 40 30
21 18
R
PGM SEARCH
A N A L O G
÷ MONO cannot be selected during recording pause.
÷ The REC INPUT cannot be changed during pause in the MONO mode.
÷ The analog "monaural long-play mode"allows to double the recording
time compared to recording in the stereo mode.
DM-9090 (En)
¢
"ANALOG" lights up
15 OVER ( dB)
12 9 7 5 3 1 0 ANALOG
1
MONITOR
DIGITAL
2 3
32kHz
44.1kHz
48kHz