Replacing The Electrolysis Tank - Sanyo VW-VF10BG Technical Data & Service Manual

2. Replacing the electrolysis tank

1 Stop the system and unplug the power cord.
2 Remove the top and bottom parts of the front panel.
3 Remove the water tank, and remove divider panels A and B
(4 screws each).
4 Remove the electrical component box cover (4 screws).
5 Remove the 3 screws that fasten the top panel, and the 16 screws that fasten the rear panel. Then lift up the
top panel (1) and pull the rear panel back in order to remove it (2).
Top panel
6 Disconnect the electrolysis tank cord (red) from the cord clips (2 locations).
Electrical component
box cover
Divider panel A
Screws (3)
Rear panel
6 - 5
Maintenance Procedures
Divider panel B
(1)
Top panel
Screws (16)
(2)
Rear panel
Cord
clips
Cord
(red)
6