Replacing The Fan Motor - Sanyo VW-VF10BG Technical Data & Service Manual

5. Replacing the fan motor

1 Stop the system and unplug the power cord.
2 Remove the top and bottom parts of the front panel, and remove the cover from the electrical component box
(4 screws).
3
Remove the pre-filter and high collection filter. Remove installation brackets A, B, C, and D (8 screws),
and remove the filters from them.
4 Press the tabs (2) on the left and right of the fan case cover toward the inside to disengage them.
Installation
bracket C
Installation
bracket A
5 Cut the binding bands inside the electrical component
box, then disconnect the motor connectors (2).
6 Insert a hex screwdriver
through the fan notch and
loosen the hexagon socket-
head screws that fasten the
fan. Next remove the
hexagon-head bolts (2) and
remove the motor support
brackets. Then pull the motor
to the right and disengage it
from the fan boss before
pulling it out toward you.
Filter
High collection filter
Pre-filter
Fan
Hexagon
socket-head
screw
Electrical
component box
Fan case cover
Installation
bracket D
Installation
bracket B
Hex
screwdriver
Fan boss
6 - 9
Maintenance Procedures
Tabs
Motor connectors
Binding bands
Hexagon-head
bolts
Motor support
brackets
Motor
6