Troubleshooting - Philips bCool XG1 User Manual

Warning
Read as follows
Problem
Image is not or incorrectly
displayed
Philips Multimedia Projector

7.Troubleshooting

If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
organisation.
Under no circumstances should you try to repair the projector yourself as this could invalidate the
guarantee.
– Possible cause
• Solution
General
– Mains lead is not correctly connected.
• Correctly connect mains lead.
– Lamp holder cover is not closed correctly or the lamp holder is damaged.
• Close the cover correctly (see 'Lamp replacement' under 'Maintenance').
– Signal cable not correctly connected.
• Connect signal cable correctly.
– The projector is in Off position.
• Press Standby to switch on the projector.
– A/V Mute active.
• Cancel A/V Mute.
In Video series mode
– Keystoning is applied on a high resolution component signal.
• Decrease keystoning until the image is correctly displayed. For this use the 'Keystone' option
in the 'Setup' menu.
In Data mode
-- Partial, scrolling or incorrectly displayed image.
• Use the 'Autosync' option in the 'Picture' menu.
– Input resolution is too high (and keystoning is applied).
• If you wish to keep the keystone correction, decrease the input resolution until the image is
correctly displayed. For this, refer to the User Guide or support information of the
computer.
• If you wish to keep the input resolution as it is, decrease keystoning until the image is
correctly displayed. For this, use 'Keystone correction' option in the 'Settings' menu.
– Input resolution is too high (and no keystoning is applied).
• Decrease the input resolution until the image is correctly displayed. For this, refer to the
User Guide or support information of the computer.
27
English User guide bCool XG1
>