[Lamp Control]; [Cooling Fast]; [Closed Caption] - Panasonic PJLink PT-LW330 Operating Instructions Manual

Note
f It is set to [Off] when using the projector in the elevation of below 1 400 m (4 593'). It is set to [On] when using the projector
in the elevation of above 1 400 m (4 593') and below 2 700 m (8 858'). Failure to do so may shorten the life of the internal
parts and result in malfunctions.
f Do not set the projector in the elevation of 2 700 m (8 858') or above, otherwise it may shorten the life of the internal parts
and result in malfunctions.
f When it is set to [On], the fan noise becomes louder and fan speed increases.

[Lamp control]

Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1) Press as to select [Lamp control].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
f You can also press the <LAMP> button on the remote control. (x page 40)
[ (Normal)]
[ (Eco 1)]
[ (Eco 2)]
Note
f Set it to [ (Eco 2)] rather than [
power consumption, extend the life of lamp and reduce operation noise.

[Cooling fast]

Switch the cooling fan' speed when the power is turned off and shorten the cooling time of the cooling fan.
1) Press as to select [Cooling fast].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Normal]
[60 Sec]
[0 Sec]
Note
f When it is set to [0 sec], you cannot restart the projector immediately after the power-off. The lamp remains high temperature
and needs to be cooled, so it sometimes takes longer time than usual for the lamp to light up again.
f When it is set to [60 sec], the cooling fans' speed is faster and the motor noise is louder than [Normal] setting after the
power-off.

[Closed caption]

(Only for NTSC input)
Set the closed caption.
1) Press as to select [Closed caption].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Off]
[CC1]
[CC2]
[CC3]
[CC4]
Note
f Closed caption is a function that displays text information of video signals mainly used in North America. Captions may not
be displayed depending on the connected devices or contents being played back.
56 - ENGLISH
Chapter 4 Settings - [Setting] menu
Select when high luminance is required.
Select when high luminance is not required.
Select when lower luminance than [
(Eco 1)], set it to [
Use this setting normally.
Use this setting when short cooling period of time is required.
The cooling fans stop immediately after power-off.
Closed caption is not displayed.
Displays CC1 data.
Displays CC2 data.
Displays CC3 data.
Displays CC4 data.
(Eco 1)] is required.
(Eco 1)] rather than [ (Normal)], when you want to reduce