NEC EXPRESSSCOPE Engine 3 User Manual page 10

subnet mask of your management LAN.
If DHCP has been used, an automatically obtained subnet mask IP address will
appear. (Default setting is 255.255.255.0.)
Default Gateway
If DHCP is not used to automatically obtain a default gateway IP address, enter the
default gateway of your management LAN.
If DHCP has been used, an automatically obtained default gateway will appear.
(Default setting is 0.0.0.0.)
DHCP
If you want to obtain an IP address, choose [Enabled].
If you want to manually configure an IP address, choose [Disabled].
(Default setting is [Disabled](*).)
Web Interface:
HTTP Interface
Select [Enabled] to use the Web Server function using the HTTP. If not, select
[Disabled]. (Default setting is [Enabled](*). )
HTTP Port Number
Specify the HTTP port number. (Default setting is 80.)
HTTPS Interface
Select [Enabled] to use the Web Server function using the HTTPS(SSL). If not,
select [Disabled]. (Default setting is [Enabled](*).)
HTTPS Port Number
Specify the HTTPS(SSL)port number. (Default setting is 443.)
Command Line Interface:
SSH
Select [Enabled] to use the Command Line Interface using SSH. If not, select
[Disabled]. (Default setting is [Enabled](*).)
SSH Port Number
Specify the BMC's SSH port number. (Default setting is 22.)
BMC Initialization
The BMC Configuration will be cleared. Please use this function when you forgot
your user name and password, etc. for remote management via a Web browser and
command line interface. This function will be executed when you select "YES" on
confirmation menu which appears after pressing the "Enter" key. This menu invokes
the BMC configuration clear operation after selecting the "YES".
• These BMC Management LAN-related settings of BMC are not
changed to default settings by executing the "Load Setup Default"
Notice
of BIOS Setup Utility. (Execute the "BMC Initialization" to set
default settings to the BMC Management LAN settings.)
• When "BMC Initialization" is executed, BMC is reset. It will take
about tens of seconds by the time initialization is completed after
it executes it.
- -
10