NEC EXPRESSSCOPE Engine 3 User Manual page 43

You can display only access log that corresponded to the specified from following condition.
• timestamp
Specify the date by the following format: MM/DD/YYYY
• user
Specify the user name.
• ipaddress
Specify the IP address on the remote management PC by the following format:
XXX.XXX.XXX.XXX
• protocol
Specify the following protocol: HTTP, HTTPS, SSH
• event
Specify the following event: normal, error
"normal" means not error event. "error" means error event.
You can change the displaying sequence of access log and display the specified number of
access log by the specified from following options.
• oemnec_headlog <number>
Display from <number> head of the access log.
• oemnec_taillog <number>
Display from <number> back of the access log.
Enter the following command when you would like to use the above condition.
e.g.1) Display the access log whose username is Administrator.
show user==Administrator
e.g.2) Display the access log whose IP address is 192.168.1.100 and protocol is HTTP and
event is error.
show ipaddress==192.168.1.100,protocol==HTTP,event==error
e.g.3) Display from 100 back of the access log whose timestamp is 10/10/2010 and protocol
is HTTPS.
show –oemnec_taillog 100 timestamp==01/01/2010,protocol==HTTPS
- -
43