System Event Log; Viewing System Event Log - NEC EXPRESSSCOPE Engine 3 User Manual

SYSTEM EVENT LOG

You can display system event log and modify setting of the system event log through the
command line interface.

Viewing system event log

To move the current default target to /admin1/system1/log1, enter the following command at
the command prompt.
cd /admin1/system1/log1
Here, to confirm the total number of system event log records, enter the following command.
The "Targets" section reported by the following command indicates the "record<N>" target(s).
<N> means any value between 1 and the total number of the system event log records.
show
To show the total number of system event log records more than 1000
event logs, it may take about tens of seconds.
Next, when the following command is input, information of a specific record is displayed at
"Properties" section: Here, <N> means record number which you would like to confirm.
show record<N>
For example, enter the following command when you would like to confirm the number 1
record.
show record1
The example of displaying information in this case is shown below.
-> show record1
Command Status: COMMAND COMPLETED
ufip=/admin1/system1/log1/record1
Properties:
RecordID=1
CreationTimeStamp=20110324130745.000000+000
RecordFormat=*RecordID*RecordType*TimeStamp*GeneratorID*EvMRev*Sens
orType*SensorNumber*EventType*EventData1*EventData2*EventData3*
RecordData=*1*2*1300972065*32*4*16*9*111*66*143*255*
Verbs:
cd
exit
help
show
version
- -
40