Remote Control; Power On; Forced Power Off; Os Shutdown - NEC EXPRESSSCOPE Engine 3 User Manual

REMOTE CONTROL

You can perform remote control of the host system at the command prompt.
Performing remote control when the operating system is running may
cause the loss of data in the host system.
Notice
The user must have an account as operator or administrator for
remote control.

Power ON

Enter the following command at the command prompt.
start /admin1/system1

Forced Power OFF

Enter the following command at the command prompt.
stop -force /admin1/system1
or
stop -f /admin1/system1

OS Shutdown

Enter the following command at the command prompt.
stop /admin1/system1
The above OS shutdown is equivalent to pressing the POWER switch
when the power of the host system is on. Your operating system
must be set to shut down when you power off the system.

System Reset

Enter the following command at the command prompt.
reset /admin1/system1
An above system reset is failed when the power of the host system is
off.
- -
35