Useful Information; Character Table; Error Messages - Panasonic KX-HNH100 Operating Instructions Manual

Character table

The dial keys are used to enter characters and numbers. Each dial key has multiple characters
assigned to it.
1
z
*1 The following characters are assigned to the 1 key when entering a Wi-Fi password.
Note:
R While entering characters, you can switch between uppercase and lowercase by pressing *
(A®a).
R To enter another character that is located on the same dial key, first press MEN to move the
cursor to the next space.
R If you do not press any dial key within 2 seconds after entering a character, the character is
fixed and the cursor moves to the next space.
R in the above table represents a single space.
Erasing the character or number
To erase a character or number, press MFN or MEN and then press MCLEARN.
To erase all characters and numbers, press and hold MCLEARN.

Error messages

Display message
Hub no power
or
No link. Re-
connect Hub
AC adaptor.
Busy
Call phone company
for your access #
For assistance, please visit www.panasonic.com/support
2 3 4
Cause/solution
R The handset has lost communication with the hub. Move
closer to the hub and try again.
R Unplug the hub's AC adaptor to reset the unit. Reconnect the
adaptor and try again.
R The handset's registration may have been canceled.
Re-register the handset (page 12).
R The called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The handset you are using is too far from the hub. Move
closer and try again.
R You have not stored the voice mail access number. Store the
number (page 30).
5 6 7

Useful Information

8 9 y
41