Sanyo PJ-Net Organizer POA-PN30 Owner's Manual page 65

3
When communication is established, the word "PASSWORD:" appears on the
window. Type the login password (PIN code) for the projection monitor and then
press "Enter" key on the keyboard. If you do not set up the network PIN code, just
press "Enter" key.
When the word "Hello" is replied, login has been succeeded.
4
Type the commands from the key board to control the external equipment and then
press "Enter" key for termination. For example, type "C00" and press "Enter" key.
* "C00" is a command to turn the projection monitor on.
- The extra projection monitor will be turned on.
To disconnect the communication, press "Ctrl" key and "]" key at the same time.
*1 Further instructions about the telnet application, please see the on-line guide on your com-
puter.
*2 The commands are defined by each product independently, so please consult the manufac-
turer or sales dealer for further information of the commands.
* The password is a network PIN code decided item "Network PIN code setting" (☞P .20, 29). If
the authentication of the entered password is failed 4 times continuously, the communication
will be disconnected automatically. Please try again for the connection.
Use of telnet
65
PJ-NET ORGANIZER
OWNER'S MANUAL