Panasonic AG-HPD24P Operating Instructions Manual page 48

Steps for setting TC/UB:
1)
Press the TC PRESET button.
The left-most digit starts flashing.
2)
Press the Up/Down cursor buttons to change the
value.
3)
Press the Left/Right cursor buttons to select digits.
The selected digits start flashing.
The setting ranges are as follows:
Time code:
User bits:
6
Repeat steps 2 - 3 to change other values.
Pressing the RESET button resets the preset value to 0.
7
When the start value is set, press the SET button.
When menu SETUP - TC/UB/CTL - RUN MODE is set to
FREE RUN, the time code starts advancing immediately.
To cancel this setting, press the EXIT button or the
CANCEL button.
■ Time code when no power is supplied
When no power is supplied, the backup function works
enabling the time code generator to provide long-term (about
one year) operation.
◆ NOTE:
• The backup function is enabled under the conditions listed below
when the time code generator advances regardless of operation
mode.
- Set menu SETUP - TC/UB/CTL - TCG MODE to PRESET, when the
SETUP - TC/UB/CTL - RUN MODE menu setting is set to FREE
RUN.
- Set menu SETUP - TC/UB/CTL - TCG MODE to EXT when input of
external time code set by the SETUP - TC/UB/CTL - EXT TC SEL
menu setting was removed from the rear panel connector.
• When menu SETUP - SYSTEM - FREQUENCY is modified, run data
is cleared.
• When menu SETUP - BASIC - VFR REC is set to ON, RUN MODE is
set to REC RUN regardless of menu setting.
48
Time Code, User Bits, CTL:
[59.94 Hz]
00:00:00:00 - 23:59:59:29
[50 Hz]
00:00:00:00 - 23:59:59:24
[23.98Hz] [24Hz] [59-23]
[60-24]
00:00:00:00 - 23:59:59:23
00000000 - FF FF FF FF
External mode
2 1
1
Press the STOP button to stop recording.
2
Use the COUNTER button to select TC.
3
Use the SETUP - TC/UB/CTL - TCG MODE/UBG
MODE menu setting to set EXT.
(External time code selection)
4
Use the SETUP - TC/UB/CTL - EXT TC SEL menu
setting to select type of external time code.
EXT LTC: Records LTC signals input to the TIME
CODE IN connector (BNC) on the rear
panel.
SLTC: Records LTC signals added to serial
signal input to the SDI IN connector.
◆ NOTE:
• When SLTC is set and an SD SDI input signal is selected, the VITC
of the input video signal is recorded.
• When menu SETUP - SYSTEM - FREQUENCY is 59-23 or 60-24,
menu SETUP - TC / UB / CTL EXT TC SEL does not appear. The unit
is locked in SLTC in this mode.
• When menu SETUP - BASIC - VFR REC is set to ON, REC RUN is set
regardless of TCG MODE menu setting.
3,4 3,4