Panasonic UF-9000 Service Handbook page 46

3.1.2. Jam Error Codes (J Code)
Code
J00 The Registration Sensor did not detect paper within a predetermined time after paper
started feeding. (Sheet Bypass)
J01 The Registration Sensor did not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (1st Feeder Unit)
J02 The Registration Sensor does not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (2nd Feeder Unit)
J43 The Exit Sensor does not detect paper within a predetermined time after the Fuser
Unit Paper Exit Sensor is activated.
J44 The Exit Sensor keeps detecting paper after a predetermined time.
J70 Read Point Sensor does not go ON within 10 seconds after the original starts feeding.
(Information Code 030 is printed on the Transaction Journal instead.)
J71 Original was longer than 78.7 in (2m).
(Information Code 031 or 032 is printed on the Transaction Journal instead.)
J79 The ADF Read Point Sensor keeps detecting paper in the ADF.
J80 The Automatic Duplex Unit (ADU) Entrance Sensor does not detect paper within a
predetermined time.
J82 The ADU Exit Sensor does not detect paper within a predetermined time after ADU
Middle Sensor is activated.
J83 The ADU Entrance Sensor keeps detecting paper after a predetermined time has
lapsed.
J90 The PRINT signal is not received within 1 minute after the FEED signal is received.
J91 The Paper Tray was pulled out when feeding a paper.
J92 The Front Cover was opened when feeding a paper.
J93 The paper remained in the ADF.
Ver. 2.0
A
Section Jam Location
A ADF
B Paper Transport / Exit Area
C Paper Entry Area
Jam Error Codes (J Codes) Table
Contents
46
B
C
UF-9000
DP-180/190
Section
C
C
C
B, C
B, C
A
A
A
C
C
C
-
C
C
A
JUN 2004