Panasonic UF-9000 Service Handbook page 68

4.1.5. F6 Mode: Adjust Parameters (For Copier)
Set the machine to Service Mode and press "6" key on the Keypad.
↓
Press the "START" key.
↓
Enter the desired code number or press "V", "/\" arrow keys.
↓
Press the "SET" key.
↓
Enter the desired function code number and press "SET" key.
↓
When the "CLEAR" key is pressed, the selected code input will not be accepted.
↓
Press "STOP" key, then press "FUNCTION" and "CLEAR" keys simultaneously to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
Note:
1. The Factory Setting is different in each model.
2. The machine may accept a (+/-) input value that exceeds the specified Setting Range for the
parameters in the table; however, the actual registered value will not exceed the Upper/Lower
Limitation value.
No.
00-02 Not Used
03 Original Registration
04 Printer Registration
05-06 Not Used
07 Registration Void
08 Trail Edge Read Timing
09 Trail Edge Print Timing
10 Side Adjust (Bypass)
11 Side Adjust (Tray 1)
12 Side Adjust (Tray 2)
13-15 Not Used
16 Side Adjust (ADU)
17-32 Not Used
33 TDC Max. Read Only
34 TDC Min. Read Only
Ver. 2.0
Item
Adjustment of platen original registration
detection timing.
Delay time is adjusted from registration roller
clutch ON.
Registration void should be adjusted.
Adjustment of trail edge void.
Adjustment of trail edge void.
Adjustment of LSU side-side (Sheet Bypass).
Adjustment of LSU side-side (1st Tray).
Adjustment of LSU side-side (2nd Tray).
Adjustment of LSU side-side (ADU).
Set by Digital QUANTUM (QUARC) control
Set by Digital QUANTUM (QUARC) control
F6 Mode
Remarks
68
UF-9000
DP-180/190
Setting
Range
-30 - +30
0.2mm
-50 - +16
0.5mm
0 - +99
0.5mm
-9 - 0
0.5mm
-9 - +15
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-99 - +99
(Read only)
-99 - +99
(Read only)
JUN 2004