Panasonic UF-9000 Service Handbook page 52

Code Mode
401 XMT
402 XMT
403 RCV
(Polling)
404 XMT
405 XMT
406 RCV
(Password
Comm.)
407 XMT
408 XMT
409 XMT
410 RCV
411 RCV
(Polling)
412 G3 RX
414 RCV
(Polling)
Ver. 2.0
Fax Information Codes
Phase Description of Problem
B DCN was returned from receiver
while transmitter is waiting for CFR
or FTT.
B DCN was returned from receiver
while transmitter is waiting for
NSF/DIS.
B Transmitter had no polling
function.
B Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond. (CFR
or FTT is usually returned)
B Transmitter received FTT after it
transmitted TCF at 2400bps.
Received RTN after
communicating at 2400 bps.
B XMT-Password mismatched.
RCV-Password mismatched.
Selective RCV incomplete.
D Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN.
D Transmitter received RTN after it
transmitted EOP, MPS, or EOM.
D Transmitter receives PIN after it
transmitted a post message, such
as EOP, MPS, EOM, etc.
D Received DCN while waiting for
post command. (EOP, MPS, EOM,
etc.)
B Received DCN after transmitting
NSC.
B, D No response within 12 seconds in
NSS/DCS/MPS wait state. (After
transmitting FTT)
B No response received after
transmitting 3rd NSC.
Your machine's ID Number is not
programmed.
Possible incompatibility or incorrect
Password.
Receiver working in non-CCITT mode
only. (Possible incompatibility)
"POLLED=ON" (polling XMT ready) is
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
Receiver is defective. (Modem)
SC PCB or FXB PCB are defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
SC PCB or FXB PCB are defective.
XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of ONE-TOUCH, ABBR
telephone number.
Receiver is defective. (No paper, paper
jamming, etc.)
Receiver ceased receiving because of
excessive error. (Line quality is poor)
SC PCB or FXB PCB are defective.
Receiver receives data with error. (Line
quality is poor)
Receiver is defective. (Modem, etc.)
SC PCB or FXB PCB are defective.
Receiver receives data with error due to
poor line quality, and receiving operator
requests voice contact.
Receiver is defective. (Modem, etc.)
SC PCB or FXB PCB are defective.
Interface or line is faulty.
Transmitter is defective.
Transmitter is not ready for polling
communication.
Password does not match between
transmitter and receiver.
Transmitter is defective.
SC PCB is defective.
Password does not match between
transmitter and receiver.
Transmitter is defective. (No original,
document jam, etc.)
52
UF-9000
DP-180/190
Cause
JUN 2004