Panasonic UF-9000 Service Handbook page 55

Code Mode
630 XMT or RCV
(Polling)
631 XMT
634 XMT
638 XMT
711 RCV
712 XMT
714 XMT
RCV
715 XMT
716 XMT
717 XMT
718 XMT
719 RCV
720 POP
721 POP
Ver. 2.0
Fax Information Codes
Phase Description of Problem
B Redial count over.
A "STOP" button was pressed during
Auto Dialing.
B Redial count over with no
response or busy tone was not
detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
LAN Power turned Off with applicable
data in memory or during
communication.
LAN Incorrect LDAP settings.
LAN Unknown email address replied
from the Mail Server.
LAN LAN Interface error.
Cannot logon to the LAN.
LAN TCP/IP connection timed out.
LAN Cannot logon to the LAN.
LAN Incomplete SMTP Protocol
transmission.
LAN Page Memory Overflow occurred
while receiving printing data. The
paper size selected within your
application to print is larger than
the paper size loaded in the
Tray(s).
LAN Received data via LAN is in a
format that is not supported.
LAN Unable to connect with the POP
Server.
LAN Unable to login to the POP Server. Incorrect User Name or Password is
No dial tone detected. Sensor dial tone
is not detected. (destination dependent)
Busy tone is detected. (destination
dependent) T1 timer (35 ± 5 sec.)
elapsed without a signal from the
receiver.
Telephone line cable is disconnected.
Wrong number is dialed.
SC or FXB PCB is abnormal.
Power switched off.
Power failure occurred.
LDAP Server Name, LDAP Login
Name, LDAP Password and/or LDAP
Search Base are incorrect.
Mail Server received an incorrect email
address. (Dependent on Server's Mail
application)
The 10Base-T/100Base-TX cable is not
connected.
An unexpected LAN problem occurred.
Check the SC PCB connector.
Incorrect IP Address is set.
Verify the IP Address, Default Router IP
Address, SMTP Server IP Address.
Incorrect SMTP Server IP Address is
set.
No email application is activated on the
Mail Server.
Mail Server's hard disk may be full.
Mail Server is defective.
Check the document size and
resolution.
Ask originator to re-send in a supported
size and resolution.
Ask the originator to re-send with a
supported file attachment:
* In a TIFF-F format.
* Image data conforming to A4/Letter
size.
Incorrect POP Server address is set.
POP Server is down.
set.
55
UF-9000
DP-180/190
Cause
JUN 2004