Call Announce Intercom (Option 10) - Fujitsu SRS-12i User Manual

Hide thumbs Also See for SRS-12i:
Table of Contents

Advertisement

Call Announce Intercom (Option 10)

The Call Announce Intercom feature allows a Fujitsu SRS 12i / 24i IP Centrex
Telephone to be set to automatically answer incoming calls. The screener
places the incoming call on hold, uses a designated Directory Number to
announce the call, and may then transfer the call. The screener can also use
this feature to deliver a message.
The Call Announce Intercom operates in one of two modes, two-way or
one-way intercom. Two-way intercom immediately activates the speaker and
3
microphone of the called digital set, allowing two-way communication.
One-way intercom activates only the speaker, leaving the microphone of the
recipient' s digital set turned off in the interest of privacy. The recipient must
press the MIC-OFF button to respond to the call screener.
Call Announce Intercom allows the ability to specify which call buttons are
activated by Call Announce Intercom Call Screeners, and provides the ability
to select up to three Call Screeners.
Note:
Call Announce Intercom is distinct from Network (Switch provided) intercom.
If a party is on a call, the telephone will ring like any other incoming call.
Ringer Always On
The Call Announce feature utilizes a Ringer Always On mode. Ringer Always
On sends a tone to users each time a Call Screener activates Call Announce
Intercom (regardless of the ringer mode).
This selection describes the requirements for setting up Call Announce
Intercom followed by the procedures to use Call Announce Intercom to
announce a call.
Call Announce Intercom on Selected Buttons
It is important to note that the set-up procedure is done only on the call
recipient' s set. Before beginning the set-up procedure, have the person who
will be screening your calls, call the phone and note how the number is
displayed on the first line of your set' s LCD. Later, this information will be
needed to be input exactly as it was displayed.
919-790-2222
To enable or disable Call Announce Intercom on selected buttons, follow
these steps:
3-16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srs-24i

Table of Contents