Procedure Of Scan To E-Mail - Toshiba e-Studio 332s Quick Start Manual

Scanning to E-mail
12
Press the and then select an
authentication method based on the
information in B-4. Then, press
- If B-4 is "Do not authenticate", select [No
Authentication]. Proceed to step 21.
- If B-4 is "SMTP", select [SMTP Auth].
Proceed to step 13.
- If B-4 is "POP", select [POP Before
SMTP]. Proceed to step 17.
13
Press the and then enter the
information in B-5.
14
Select [Enter] and then press
4
15
Press the and then enter the
information in B-6.
16
Select [Enter] and then press
Proceed to step 21.
17
Press the and then enter the
information in B-7.
18
Select [Enter] and then press
19
Press the and then enter the
information in B-8.
20
Select [Enter] and then press
21
When the setup menu screen is
displayed, press .
22
For the confirmation message, check
that [Yes] is selected and press
The setup for Scan to E-mail is complete.

Procedure of Scan to E-mail

.
OK
This section explains how to start Scan to
E-mail. The following procedure uses the direct
input method for specifying a destination.
You need to configure the initial network and
e-mail settings before using the Scan to E-mail
function.
Memo
● The following procedure uses the factory default settings.
1
Press the <SCAN> key on the operator
panel.
.
OK
.
OK
.
2
Place your document in the ADF or on
OK
the document glass as below:
● ADF
Load documents face up with the top edge of the
documents in first.
.
OK
Adjust the document guides to the width of your
documents.
.
OK
- 60 -