Ring Delay Per Incoming Msn; Allocating Numbers - Siemens 4075 Operating Instructions Manual

You can use the
Step
handsets 11 and 12 and switch to the MSN 22222 for this dialling procedure in
by
the process. This is not possible for handsets 13 and 14 as an alternative MSN
Step
was not set up.
Answering machine (AM) 1 was allocated to business use and AM 2 to
personal use.

Ring delay per incoming MSN

Using the ring delay feature you can configure a handset for each individual
incoming MSN to delay response to the call signal. However, during this ring
delay time the Comfort handset can accept the call using the "call pickup"
function without a call signal queuing. When this feature is being configured,
the time allowed by the answering machine for recording a message (default:
Automatisch 2/4) must be taken into account. When the ring delay that has
been set is higher than the setting on the active AM, there is no call signal as
the answering machine accepts the call beforehand. Setting ring delay see
page 31.

Allocating numbers

The Installation Assistant makes it very easy to perform the initial configuration.
After initial installation you can call up the Installation Assistant at any time; to
skip programming of the feature use the [NEIN] key and the next feature will
be displayed.
20
MSN nächst.Wahl feature by allocating two MSNs to the